Middle East
SIP Trunk Kuwait — +965 Termination & DID Numbers
Kuwait has a closed eight-digit plan: landlines start with 2 and mobiles with 5, 6 or 9. Most termination goes to mobiles, so ask for the mobile lines on the rate sheet rather than the fixed-line rate.
Overview
Routing calls to Kuwait
Calling windows matter: Kuwait runs on Kuwait time, and we route +965 calls for Kuwait City, Hawalli and Salmiya, Farwaniya and Jahra across several carriers so a peak-hour congestion event on one network does not take your campaign down.
The national telecom regulator sets the Kuwait numbering plan, and our prefix tables follow it closely. Supported number types: geographic and mobile. There is no trunk prefix to strip: send 965 followed by the national number as written.
Local numbers in Kuwait are tightly controlled, so availability changes over time. Termination is available now. For DIDs, email sales with your use case and we will tell you what can be supplied compliantly.
What you get
What you get in Kuwait
One account and one balance, with the same SBCs for termination and inbound numbers.
CLI route tier
Caller ID delivered end to end on +965 calls. Use it for sales, support and any traffic where answer rates matter.Non-CLI route tier
A lower-cost tier where caller ID delivery is not guaranteed. Suitable for internal or transactional traffic that does not depend on the CLI.Number types
Geographic, Mobile. DID availability varies by range and city.Codecs
G.711a/u and G.729 on every route, G.722 and Opus where the far end supports them. T.38 for fax.Channels on demand
Concurrent call limits are set per account and raised as your traffic grows. No fixed channel bundles.Multi-carrier failover
Every +965 prefix is mapped to more than one carrier. Failed attempts move to the next one automatically.
Number formats
How to dial Kuwait from your PBX
Send E.164 digits. The sample number below shows the format only.
| Format | Example | Notes |
|---|---|---|
| International (E.164) | +965 2212 3456 | How the number is written and stored. |
| Sent from your PBX | 96522123456 | E.164 digits with no plus, prefixed by your tech prefix if your account uses one. |
| With 00 exit code | 00 965 2212 3456 | Accepted on the trunk. We normalise it to E.164. |
| National format | 2212 3456 | Dialled inside Kuwait. There is no trunk prefix. |
Compliance
Kuwait rules to know
What applies before your first call or your first DID goes live.
Compliance box
- Regulator
- The national telecom regulator
- Caller ID
- A valid CLI that you are entitled to use is required on CLI routes. Spoofed or unallocated numbers are blocked.
- DID KYC
- Check with sales
Rules change — our team confirms current requirements before activation.
Use cases
Who uses Kuwait routes
- 01
Regional sales teams calling Kuwait City businesses
- 02
Banks and retailers reaching customers on Kuwaiti mobiles
- 03
Expat communication services terminating into Kuwait
Setup
Start calling Kuwait in 3 steps
- 01
Top up $200
Open a prepaid account and add balance by USDT (TRC20), BTC or card. - 02
Add your trunk
Whitelist your PBX IP or create digest credentials, then point your outbound route at our SBC. - 03
Dial +965
Send 965 + national number in E.164 and check the CDR for your first test call.
Further reading: CLI vs Non-CLI Routes: What Actually Changes for Your Calls
FAQ
Kuwait SIP trunk questions
Does Kuwait have area codes?
No. Numbers are 8 digits. Send 965 + 8 digits.
Who regulates Kuwaiti telecoms?
The national telecom regulator. We confirm current requirements before activation.
Can I get Kuwaiti DIDs?
Availability is very limited. Ask sales.
Are mobile and fixed rates different?
Yes, and mobile termination is usually the higher of the two.
